sonoma problem

[AliKurt1337]

The situation is as follows, I have monterey booting fine on this bootloader, but when I try to update or install a clean sonoma the bootloader just stops, and no problems are detected by debug

 

[RyzeCooker]

Which version of OpenCore? Latest cpu patches? All kexts updated? Monterey > Sonoma is a big jump and things need to be updated, especially the cpu patches.

 

[AliKurt1337]

Which version of OpenCore? Latest cpu patches? All kexts updated? Monterey > Sonoma is a big jump and things need to be updated, especially the cpu patches.

oc 0.9.5
AMD's latest patch Vanilla OpenCore is installed.
all kexts are updated to the latest version

 

[Edhawk]

What system are you using? Motherboard, CPU, dGPU, WiFi/BT, Ethernet etc?

Without this information it is nearly impossible to tell what is correct and what is wrong with your OC setup. As a quick review of your config.plist doesn't show anything untoward.

 

[AliKurt1337]

I'm sorry

PC specs:
msi b350m gaming pro
Ryzen 3500x
RX 5500x
16GB RAM
Realtek RTL8111H
Realtek ALC887

 

[AliKurt1337]

What system are you using? Motherboard, CPU, dGPU, WiFi/BT, Ethernet etc?

Without this information it is nearly impossible to tell what is correct and what is wrong with your OC setup. As a quick review of your config.plist doesn't show anything untoward.

I've seen similar situations on the forum, but I never realized whether he solved them or not.

B450 - Ryzen 3600 - RX 5700 - Update from 12.6.3 to 13.3 Stuck at "kdp_core zlib memory 0x7000"

System boots up just fine on Monterey, but whenever I try to boot up the "MacOS Installer" option from the boot menu it alwas gets stuck at kdp_core zlib memory 0x7000. I tried updating to both 0.9 and 0.9.1, the AMD patches are up-to-date, tried running the update multiple times and the bios...

forum.amd-osx.com

 

[Edhawk]

Try this OpenCore 0.9.5 EFI.

See if this gets you any further after the Verbose Text has finished.

I am assuming you have set your bios correctly, i.e. used the settings shown in the link below to configure your system bios.

# AMD Bios Settings

• I have set Booter > Quirks > ResizeAppleGpu Bars to '0'.
• I have not added the npci=0x3000 boot argument.

 

[AliKurt1337]

Try this OpenCore 0.9.5 EFI.

See if this gets you any further after the Verbose Text has finished.

I am assuming you have set your bios correctly, i.e. used the settings shown in the link below to configure your system bios.

# AMD Bios Settings

• I have set Booter > Quirks > ResizeAppleGpu Bars to '0'.
• I have not added the npci=0x3000 boot argument.

I tried with your efi - the result is the same, both on Install Sonoma and on Mac install, with Monterey logged in normally

I also attach bios settings, maybe I made a mistake somewhere.

 

[AliKurt1337]

.

 

[Edhawk]

The Bios settings shown in the screenshots above look ok.

 

[AliKurt1337]

The Bios settings shown in the screenshots above look ok.

That's the problem, it's not him.