Hello all. Question: I am running the AMD OpenCore 0.5.9 Hackintosh. My setup is as follows: AMD b350 Tomahawk Motherboard, M.2 Samsung 970 Evo, 16GB RAM at 3200MHz, GTX 1080 Ti.
I am using MacOSX High Sierra 10.13.6. Everything is working perfectly fine. I built a custom DTST specific for my board and USB ports and made sure to enable the .aml file in the config.plist. All of my motherboard's USB ports work: 2.0, 3.0, 3.1 gen 2 (respectively).
My only issue is while using one of my USB 3.0 ports as a HUB via, my monitor which splits one port into 4 USB 3.0 ports, MacOS sees this HUB, but when I insert anything into them nothing occurs. I am being a little 'picky' but I want it all; the full experience and I don't mind learning.
If you have the knowledge please be helpful *(very important)
I am using MacOSX High Sierra 10.13.6. Everything is working perfectly fine. I built a custom DTST specific for my board and USB ports and made sure to enable the .aml file in the config.plist. All of my motherboard's USB ports work: 2.0, 3.0, 3.1 gen 2 (respectively).
My only issue is while using one of my USB 3.0 ports as a HUB via, my monitor which splits one port into 4 USB 3.0 ports, MacOS sees this HUB, but when I insert anything into them nothing occurs. I am being a little 'picky' but I want it all; the full experience and I don't mind learning.
If you have the knowledge please be helpful *(very important)