Booting into the prohibited symbol
- Thread starter momchilh
- Start date
-
Hello Guest. Before you post check the Troubleshooting guide here, Dortania Troubleshooting
Booting in to a prohibited symbol usually means the USB port you are using for the installer has been dropped as part of the switch from Bios control, to OpenCore control and finally to the macOS installer control.
Often a USB port that happily boots the OpenCore EFI and installer will be dropped by macOS, due to USB configuration issues in the OpenCore setup being used. An incorrectly configured UTBMap.kext or USBMap.kext or the total lack of a custom USB configuration is the normal culprit for this issue.
Looking through your EFI's Kext folder it is clear that you lack a custom UTBMap.kext to pair with USBToolBox.kext. The later kext does nothing on its own. You need to run the USBToolBox Tool in Windows, discover the system USB ports and generate a custom UTBMap.kext for your system to have working USB ports.
If the system lacks a custom USB configuration then this more often than not leads to USB port failure during the installation phase.
I assume this is your initial installation of maCOS on this B850M system. That being the case I would recommend you try running an earlier version of maCOS, Ventura, Sonoma or Sequoia would all work better than Tahoe as a first time installation.
Your EFI isn't configured for the installation of macOS on any B850 motherboard, To be honest I don't think it would work on any AMD Hack.
You need to do some more research and read through the guides over at Dortania's OpenCore site.
Your alternative is to look to see if anyone else has managed to install macOS on the same or a similar 800 series AMD board as you are using and use their EFI as a base.
Often a USB port that happily boots the OpenCore EFI and installer will be dropped by macOS, due to USB configuration issues in the OpenCore setup being used. An incorrectly configured UTBMap.kext or USBMap.kext or the total lack of a custom USB configuration is the normal culprit for this issue.
Looking through your EFI's Kext folder it is clear that you lack a custom UTBMap.kext to pair with USBToolBox.kext. The later kext does nothing on its own. You need to run the USBToolBox Tool in Windows, discover the system USB ports and generate a custom UTBMap.kext for your system to have working USB ports.
If the system lacks a custom USB configuration then this more often than not leads to USB port failure during the installation phase.
I assume this is your initial installation of maCOS on this B850M system. That being the case I would recommend you try running an earlier version of maCOS, Ventura, Sonoma or Sequoia would all work better than Tahoe as a first time installation.
Your EFI isn't configured for the installation of macOS on any B850 motherboard, To be honest I don't think it would work on any AMD Hack.
You need to do some more research and read through the guides over at Dortania's OpenCore site.
Your alternative is to look to see if anyone else has managed to install macOS on the same or a similar 800 series AMD board as you are using and use their EFI as a base.