Recent content by treyvaud

Thanks, though I'm not sure what I'm missing here? I would seem to need the following AML files: SSDT-HPET SSDT-EC SSDT-USBX SSDT-PLUG SSDT-USB-RESET SSDT-XOSI I am doing the mapping correctly using USBTool in windows, and have the correct type of port assigned, then when I boot into Mac, the...

Hey Edhawk, I bit the bullet and rebuilt the entire thing from scratch (again). I have most of the USB ports working now and most things are working. I've also run SSDT time from MacOS and patched the IRQ's, and combined them into the EFI 1. I have mapped the USB ports in windows, do I also...

Thank you. I've run the USBtoolbox from windows to map all the ports and followed the instructions to the letter, and now when I reboot with the kexts in the folder and config.plist none of my USB ports work..... Is there any guidance available please?

Thanks Ed! Everything else is working fine, it's just the USB mapping which doesn't seem to be working.

Thank you. The NVMe drive is fine, but my USB ports aren't. I can't seem to get the USB3 port working when in MacOS - are there any pointers for getting the mapping correct? I used the usbmap in windows and mapped the ports correctly, but even after adding the kext and rebooting it didn't...

Thanks, much appreciated

Thank you. I'm using a mini PC, not a laptop hence I wasn't sure. Thanks for the heads up, assuming I will still need to map all my USB ports correctly?

Hello lovely people, I've managed to get almost everything working, but VDA - Decoder Failed is showing up in Hackintool. I've tried macpro1,1 imac20,1 macpro6,1 macpro7,1 and macbookpro16,3 with the same effect. Apart from that, most things seem to be working. Please help?! Graphics...

Okie dokie, think I got pretty much everything working. The question is - which SMBIOS should I be using? I can see that according to nootedred, it should be only imac20,1 or macbookpro16,3, imacpro1,1.

Hi there, here it is :)

Hi there everyone, happy Sunday! I've removed the device properties and it seems to be working for the install, but it's REALLY slow and I can't seem to even get Sequoia installed currently - using iMac20,1 SMBIOS. I'm using a Trigkey S5 which I believe is the same as a Beelink SER5 - I've...

Hi there, thank you for your assistance so far. I've removed the device properties and it seems to be working for the install, but it's REALLY slow. Currently using iMac20,1 SMBIOS. I'm using a Trigkey S5 which I believe is the same as a Beelink SER5 - I've attached my updated config.plist...

So I should delete all of these?

HI there, I rebuilt the machine as I FUBAR'd it by rebuilding the EFI. Think I have most things going again now, but could use some guidance on the specific settings for the AMD iGPU Vega 8. I'm using the latest Nootedred. Should I delete all the device properties out of here?

Hi all, I rebuilt my hackintosh, and now it's rebooting even though I'm using the same control.plist etc. Any ideas on what's causing the panic please? :)