First of all, I cannot install Catalina on my PC using Opencore (0.6.0) because I get stuck on the 2nd stage of installation. The OC menu, on reboot, does not display the new disk with the newly installed macOS install system on it.
Second, I have already successfully installed Mojave (Vanilla) onto a disk using CLOVER and some kernel patches published a few months ago (I cannot find them online anymore, but I have them if anybody wants them), so there is a precedent of CLOVER working on FX-6300 successfully, while OC does not.
Third, I got some experimental patches published on this site by Shaneee (Clover experimental patches for 10.13.x 10.14.x 10.15.x) for Clover and I managed to build a Catalina Vanilla Installer for Clover for my PC (FX-6300 15h). It boots into Clover (r5120) and I start the Install system boot but then I get kernel panic.
Below are a photo of what I get until I get kernel panic and the file for my EFI/CLOVER configuration and config.plist
Anybody who might know what is going on, please let me know.
Thanks
Second, I have already successfully installed Mojave (Vanilla) onto a disk using CLOVER and some kernel patches published a few months ago (I cannot find them online anymore, but I have them if anybody wants them), so there is a precedent of CLOVER working on FX-6300 successfully, while OC does not.
Third, I got some experimental patches published on this site by Shaneee (Clover experimental patches for 10.13.x 10.14.x 10.15.x) for Clover and I managed to build a Catalina Vanilla Installer for Clover for my PC (FX-6300 15h). It boots into Clover (r5120) and I start the Install system boot but then I get kernel panic.
Below are a photo of what I get until I get kernel panic and the file for my EFI/CLOVER configuration and config.plist
Anybody who might know what is going on, please let me know.
Thanks
