Welcome to AMD OS X

Why not register now to gain full access.

Help with AMD OS X after installation.
User avatar
by: nathanh0
#47855
Hi there!

I was able to successfully install Mojave 10.14.4 on my PC to SSD but when trying to boot with Clover to the SSD I am stuck at EndRandomSeed.

I have been through almost all of the EndRandomSeed posts, but have come up empty handed.

I know that it's related to memory.

I am using the prelinkedkernel patch method.

Motherboard: Gigabyte GA-990-FX UA3
Processor: FX8150
Video Card: NVidia GTX960 2GB
SSD: 128 GB
Memory: 32 GB [4 x 8 GB]

Before anyone comments on the video card, I know it will not perform - NVidia is dropped in Mojave.

Another thing I noticed during pre-install / reboot after install was "USBController" messages spamming with "Hardware Exception" and "attempting recovery".

Before I go and spend $600+ on an Intel, would anyone be able to help me out?

Also would anyone know which video card I should get for this motherboard that will be supported in Mojave?

Thank you!
Post Merged
I see now, Mojave 10.14.4 is not yet supported.

I think I'm going to just settle for High Sierra.

Hopefully I can try again later.

 Advertising

Hmm weird. I'm using the lastest 17h but my OpenCL[…]

Ok cool, and do I have to add the kext folder that[…]

It won't be stuck on pmtelemetry. You've posted th[…]

Installation

same here anyone got any ideas?