Welcome to AMD OS X

Why not register now to gain full access.

Read this thread:viewtopic.php?f=52&t=5595 - He says to install via USB 3.0, I'll try that now. Re-install it because I only get a bunch of plus signs on boot, nothing else starts.
So it was called macOS Install on Mac OS lol I'm trying to see if I can make it boot now.
Not sure, says space is taken up on HDD but the USB drive doesn't load the Mac install, just the damn installer all over again.
So I didn't monitor it and I'm not sure it installed, redoing it.
Started the installer up, is a bit slow but probably just my USB. So far it's installing now.
Was my fault, had to select under View the show all devices, then do the top WDC drive, not the partition itself. Duh.
I used disk utility on my standard HDD. Did mac journaled. Thing says it's not a GUID partition table scheme so I can't install to it -_- may have to reboot and do this again
Loaded the installer!
Can't believe that freaking worked it got me into the Apple load screen now. "Now I am trying to enable web drivers and not set nv_disable=1" but we will see if it fully loads
So right now I am trying to just get into the installer. First attempt with nv_disable=1 (I have no onboard gfx btw) didn't boot. Halted with error code 1 toward the end in verbose output.

Now I am trying to enable web drivers and not set nv_disable=1

CPU: AMD 8350
PSU: Thermaltake 500W 80+
RAM: Patriot 8GB DDR3 2x4GB 1600mhz
Mobo: MSI 970 Gaming

Post Merged
Damn guys, no one replies?


I updated 10.14.1 to 10.14.5 from the app store an[…]

After installing 10.14.1, the app store kept pulli[…]

try usb 2.0 Post Merged try usb 2.0 or usb 2.0[…]


:thumbup: Post Merged :cool: