Sonoma 14.2 beta3 booted by legacy OpenCore 0.9.5 in FX-6300 hackintosh

[jsl2020]

My FX-6300 hackintosh can boot Sonoma 14.2 beta3 & Ventura 13.6.3 by legacy OpenCore 0.9.5 with ProvideCurrentCpuInfo quirk enabled without red screen panic or blank screen issue now after its GPU RX-560 replaced by R9 270 and config.plist modified.

My config-OC-M5A.plist is attached for your reference.

 

[Mushie]

HI,
Would you please share the guide you followed to get your FX6300 working with Ventura & Sonoma? I am very new to OpenCore and feel a bit over-whelmed. I have successfully followed this guide (which has all the hard work already done) to get Sonoma & Ventura running on AMD 3700X, but would rather have my VMs on a secondary PC that runs FX6300.

Following the same guide on the FX6300 results in "The firmware encountered an unexpected exception. The virtual machine cannot boot." FYI - I have installed and booted MacOS up to Monterey on the FX6300 but, again, would prefer to have Ventura and/or Sonoma on it.

Thanks!

 

[QCherry]

I have a problem with installation on FX-8320E, RX 580 8gb logs:

https://pastebin.com/T8L8SHuK

 

[Edhawk]

@QCherry Which motherboard are you using with your FX 8320E?

If it has a UEFI bios you might be better served using one of the later EFI's , post #28, from the thread linked below.

Success - Asus Sabertooth 990FX R2.0 / FX 8350 / Nvidia GTX 690 / OC 0.7.6 - Big Sur 11.6.2 & Monterey 12.1

I have been playing around with my old AMD FX 8350 system (again) and decided to see if I could get it running macOS Big Sur. I used OpenCore 0.7.6 and followed the Dortania AMD Bulldozer guide when creating the EFI folder. I created my macOS Big Sur USB installer using the following...

forum.amd-osx.com

 

[QCherry]

@QCherry Which motherboard are you using with your FX 8320E?

If it has a UEFI bios you might be better served using one of the later EFI's , post #28, from the thread linked below.

Success - Asus Sabertooth 990FX R2.0 / FX 8350 / Nvidia GTX 690 / OC 0.7.6 - Big Sur 11.6.2 & Monterey 12.1

I have been playing around with my old AMD FX 8350 system (again) and decided to see if I could get it running macOS Big Sur. I used OpenCore 0.7.6 and followed the Dortania AMD Bulldozer guide when creating the EFI folder. I created my macOS Big Sur USB installer using the following...

forum.amd-osx.com

I have Asrock 970 extreme 3 2.0. (have UEFI )

 

[Edhawk]

You don’t want to use a Legacy OpenCore setup, if you have a UEFI Bios.

The Bios screenshots in the linked thread might help too.

 

[QCherry]

You don’t want to use a Legacy OpenCore setup, if you have a UEFI Bios.

The Bios screenshots in the linked thread might help too.

Problem is i sucessfully going to installer but when i have 12 min to end the installer give me error (i have uefi opencore and trying install sonoma).

This is logs: https://pastebin.com/T8L8SHuK