Laptop Acer A515-45 Ryzen 7 5700U w/ BCM94360NG card - bluetooth works, no wifi, no list Hackintool

[rapht1]

I have a problem with my Acer a515-45 with R7 5700u. The BCM94360 wifi does not recognize the Hackintool at all, but the bluetoth works perfectly. It appears on the PCIe, I do all the procedures to activate it (I insert the Kexts for the Sonoma), I run OCLP and it recognizes modern wireless, applies the patches without giving an error, but it does not activate, since theoretically, it does not "exist" in the system. Any tips?
USBs are Mapped. The same wifi card, on my PC x99 Hackintosh and on the windows of this laptop, works normally.
Everything else works perfectly.

 

[Edhawk]

If you are using NootedRed.kext to get the AMD IGPU working in macOS, then you shouldn't have ANY DeviceProperties in your config.plist, as these usually clash with NRed.

For Broadcom BCM4360 WiFi to work in Sonoma you need to implement the OpenCore Legacy Patches.
See this guide/thread over at Tonymacx86 for how to fix the issue, especially if you are running Sonoma 14.4 or newer.

https://www.tonymacx86.com/threads/fenvi-t919-and-broadcom-wifi-back-in-sonoma-with-oclp.326545/

 

[rapht1]

As I had already reported, in other attempts I had already applied the OCLP patches. Even on the Ventura, whose card is native, the system does not recognize it. I deleted all device properties, but it still didn't work. If I can get MacOS to recognize it in the peripherals in Hackintool, the problem will be solved. I just have no idea how to solve it.

 

[Edhawk]

Did you read the section about the changes required since Sonoma 14.4 was released?

https://www.tonymacx86.com/threads/fenvi-t919-and-broadcom-wifi-back-in-sonoma-with-oclp.326545/post-2400122

You are obviously using the latest OCLP release, so that shouldn't be an issue.
However the version of IOSkywalkFamily.kext you are using is not the correct one, read the link above and extract below.

Have you replaced IOSkywalkFamily.kext, current version is 1.0.0, you have to change it to version 1.1.0, available on the OLCP GitHub >> payloads >> Kexts >> Wifi >> Link
How to make the IOSkywalkFamily.kext change?

• replace IOSkywalkFamily.kext, revert OCLP root patch and reboot
• apply root patch of OCLP 1.4.2 or newer and reboot.

I would recommend removing FakeSMC.kext and just leaving VirtualSMC.kext in place. The two SMC kexts aren't supposed to be used in the same setup.