Search results

@Edhawk its helped me too.

I followed EdHawk's guide (https://forum.amd-osx.com/threads/clean-install-tahoe-asus-tuf-strix-x570-f-gaming.6134/) and used the EFI only kexts (NootRX) from there, along with my existing config.plist (boot unfairgva=6) and my custom USBMap.kext and Tahoe installed without issues. It looks...

I recreated the USBMap.kext as per the shared guide but still stuck at below , allow attached the new EFI. can you please check.

Thanks let me try that.

Hi @Shaneee @Edhawk @CaseySJ can you please have a look to this.

Hi all, I need some help troubleshooting my EFI setup. The attached EFI works perfectly with macOS Sequoia, but it fails with Tahoe. I already recreated the USB kext using USBToolBox, but the system still hangs at , and a few seconds later it stops at Could someone check what I might be...

Same issue even after upgrading my Samsung monitor firmware :confused:

let me try this too.

thnx will try with diff DP cable.

Yes, I have an HDMI cable for another machine with a single monitor. I also tried using a single DP cable, but the issue persists. Could it be related to a setting in the config.plist file or a missing kext?

I tested both DP versions 1.1 and 1.2, as supported by my monitor.

Which type of connection and cable were you using before you obtained the new Samsung display? HDMI which was working fine. Are you using a good quality, fully functional DP to DP cable, i.e. no kinks or bends affecting either end? I checked with my TV cable is good. Have you unplugged and...

@CaseySJ @Edhawk @Shaneee @leesurone can you please help me to fix it.

Hi All, I recently purchased a new monitor (Samsung LS24A600UCMXUE), which comes with three ports: HDMI, DisplayPort (DP), and USB-C. While HDMI works perfectly, I encounter the message "No Signal - DisplayPort" when using the DP connection. Here are the observations: 1. The signal is...

here is my whole EFI folder.

Yes it's enabled. 😥

@Edhawk I tried this but no luck. As of the OC 1.0.3 release, should it automatically detect my CPU (Intel i9 14900K)? Please correct me if I'm mistaken. I've attached my config file as well. Could you take a look and let me know if I missed anything?

Hi Everyone, I’ve updated my OC to version 1.0.3, but my CPU is still showing as "unknown." What settings do I need to adjust in 1.0.3 to ensure my Intel Raptor Lake CPU is correctly detected?

They replaced my graphics card with an Asus Radeon RX 6800 XT and I simply added the -radcodec option to the boot arguments, without altering any EFI or BIOS settings. Everything is working smoothly now.

It's new and working fine with windows 11.