Recent content by Dasboot5

@Edhawk ,@Shaneee Possibly, but I found someone who had attempted it and failed. (I have no idea what skill level he had.) Not even close to yours or Shaneee's. I bought a used Dell version, and I will make an attempt, not sure if you can block one of the two GPUs. Further, it looks as if Wi-Fi...

@Edhawk, Thank You... Here is some more info on Vega M AMD's Vega M (like in the Radeon RX Vega M GL/GH) is different from the Navi architecture. Vega M is based on the older Vega architecture, while Navi represents a newer generation of AMD GPUs. Vega M was a semi-custom design, a collaboration...

@Edhawk, Is it possible to use this AMD Vega variant in a Laptop that has an Intel i7-8705G APU and AMD RX Vega M? This is an 8th-generation Processor, which should be no problem, but the graphics may not work as Apple never implemented this co-produced processor in any of their laptops. Unless...

@Edhawk , and you'll find the entries you need (refer to this MMIO Whitelist guide) THIS LINK has BEEN PULLED, AND OR, IS NO LONGER VALID. Is there another location for a guide on whitelist creation on AMD boards???

1. Number one you do not have your motherboard listed in anyway, but we could safely assume this is an AM4 board in a laptop. 2. You Propbably need SSDT CPUr.aml created properly or prebuilt. 3. You have NO USB map most likely your bighest problem. 4. there are SSDT's that are probably not...

1. I have not tried Edhawk's whitelist in the original 1.0.3 booting EFI yet. 2. I have Tried Edhawks whitelist with the 1.0.4 debug Flash drive installer as a booter for the 15.2 Sequpia that boots with the 1.0.3 release. It will not boot. It is a combo of both of your config.plist changes...

@fabiosun I finally got some stability by adding a USB rename and redoing the USB map. However, the MIMO whitelist section was not done properly. I have attempted to run a debug version of 1.0.4 Sequoia as a test as the running version is 1.0.3. I have attached the Debug log created as it goes...

@fabiosun I finally got some stability by adding USB rename and reding USB map. However, the MIMO whitelist section was not done properly. I have attemoted to run a depug verssion of so

@fabiosun, Added some lines in MIMO whitelist area, and enabled both of the booter quirks: DevirtualiseMmio DisableVariableWrite Proceeded further but still halted. Enabled CPUR ssdt and "Voila" booted to installer!!!! Happy days. Thank you, Fabio and Edhawk. (Sequoia 15.2 installer) Lines added:

will enable, here is boot screen halt pic with a Ventura boot attempt minutes ago. (the quirks above are not enabled yet) Could you explain debug process, I know how to download debug version and recreate EFI rather than using release, are there settings for debug you wish enabled and any other...

1. Have not tried to create or add SSDT-SBUS-MCHC-AMD.aml 2. Disabled SSDT-CPUR.aml did not help boot 3. Changing PAT for Sequoia did not help 4. 3 separate Controllers show in USBToolbox setup, Bluetooth shows on a separate controller. 1st controller has 13 ports mapped out of 18, I removed...

@craighazan and @Edhawk, Is it possible for one of you two to help me with installing Sequoia on this B650 board? I will supply bios settings, pic of boot screen where it halts, and EFI I am using with serials removed, to determine what I am doing wrong or maybe missing in my attempts. GPU is...