No sound output :/

[Tyoma]

Hey all, so after reinstalling Monterey, I can't get my sound work :/ (Had no problems before)..


Any suggestions? :/

 

[Shaneee]

Set your layout-id as 07000000. If 7 doesn't work try others.

 

[Tyoma]

Set your layout-id as 07000000. If 7 doesn't work try others.

Already tried every id possible... before I did fresh install of WIN11 & Monterey, I was on layout 7 without any problems..
(Reinstalled Realtek drivers on win and was able to see my headphones&mic) but still no 3.5 rear speakers.. :/

 

[Shaneee]

Out of curiosity try with 15000000. That's what I use on my ASUS board with the same controller. Also check you've not got alcid=x set in the boot args as they'll conflict.

 

[Edhawk]

The Boot Argument will take precedence over the DeviceProperties entry, if you have both enabled.

 

[Tyoma]

Out of curiosity try with 15000000. That's what I use on my ASUS board with the same controller. Also check you've not got alcid=x set in the boot args as they'll conflict.

I'm starting to give up.. everything was working fine before I reinstalled osx...
I tried to insert my old rx 570 , to use a monitor that I had before upgrade... also tried without usb headphone..
tried every possible id, nothing works :/
acording to Dortania, this shouldn't look this way :

Fixing audio with AppleALC | OpenCore Post-Install

OpenCore Post-Install guide

dortania.github.io

No ideas left

Here is my config.. maybe I missing something

 

[Tyoma]

I almost gave up on this, but then I saw an old efi backup folder that I made a couple of months ago.. So I decided to try something:
I used Applealc 1.6.6 instead of the last one anddd Everything works now!

 

[Edhawk]

Are you still using the SSDT-PLUG.aml table in your old /EFI/OC/ACPI folder.

This table is not meant to be used with an AMD CPU. It is only meant for use with Intel CPU's. It should be removed from your /EFI/OC/ACPI folder and the config.plist if present in your old setup.

 

[Tyoma]

Are you still using the SSDT-PLUG.aml table in your old /EFI/OC/ACPI folder.

This table is not meant to be used with an AMD CPU. It is only meant for use with Intel CPU's. It should be removed from your /EFI/OC/ACPI folder and the config.plist if present in your old setup.

Yes, i was using it for AGPMinjector for my RX570...
Thanks for mentioning this! I'll delete it (just upgraded to RX6600XT)