can't boot opencore 0.58

[eddysun]

Hello people, well ... I currently have a distribution of AMD high sierra 10.13 installed but I have had many problems and I was encouraged to try this from vanilla, I followed the guide of amd-osx, some things I did not understand very well, because I am a beginner in this and when finished, I boot from the usb and it stays in watchdog, wait 30 minutes and nothing happened what can it be?

CPU: AMD FX 6100
MB: GIBABYTE GA-970-D3
GC: NVIDIA GTX 560 TI

 

[Shaneee]

It could be your GPU, you may need to use the nv_disable=1 boot arg. Also run your config through this, https://opencore.slowgeek.com/

 

[eddysun]

Hello, i have corrected everything, I also put nv_disable = 1 and the same thing keeps happening to me.

Isn't it a problem that I currently have clover installed? because I loaded the high sierra with the usb installed and I take opencore nv_disable = 1

 

[spykor]

Hello people, well ... I currently have a distribution of AMD high sierra 10.13 installed but I have had many problems and I was encouraged to try this from vanilla, I followed the guide of amd-osx, some things I did not understand very well, because I am a beginner in this and when finished, I boot from the usb and it stays in watchdog, wait 30 minutes and nothing happened what can it be?

CPU: AMD FX 6100
MB: GIBABYTE GA-970-D3
GC: NVIDIA GTX 560 TI



View attachment 81

Don't use Opencore boot loader. Use Clover (r5116 or r5117). Follow my instructions from here and you might install macOS (High Sierra or Mojave) onto your PC. I have a system with FX-6300 on a Gigabyte 990XA-UDE motherboard and a Gigabyte (NVIDIA) GT730 2GB Silent graphics card witch is Metal compatible, so I don't have any problems there. Your graphics card might be a problem. Either buy a NVIDIA GT730 (they only cost around $30) or an AMD RX 560 (works out of the box also) for around $130 which allow you for decent game playing and I think you'll have a decent Hackintosh.