Search results
-
Update to 12.3
Hi, just updated to 12.3 was getting boot loop, installed AppleMCEReporterDisabler.kext now no boot loop. Disabled the AppleMCEReporterDisabler.kext and it goes back to boot looping, enabled the kext again and it boots OK, looks like 12.3 will not work without it.- wintersun52
- Post #13
- Forum: 12.0 Monterey
-
Solved: Stuck at IOConsoleUsers: gIOScreenLockState 3, hs 0, bs 0, now 0, sm 0x0 with GT710 (GK208)
Just figured it out had to convert EFI into zip. So here is my EFI OpenCore 0.6.7.- wintersun52
- Post #35
- Forum: 10.15 Catalina
-
Solved: Stuck at IOConsoleUsers: gIOScreenLockState 3, hs 0, bs 0, now 0, sm 0x0 with GT710 (GK208)
Hi, Forum will not upload my EFI, I got it working by setting - Enabled on Kernal Patch 39 to (No) and Kernal Patch 38 to (Yes), hope this helps.- wintersun52
- Post #34
- Forum: 10.15 Catalina
-
Please help ! BCM94352Z Wifi not work
Had the same problem, it is caused by the AirportBrcmFixup.kext I fixed it by going to kext folder click on the kext and show package contents go to plugins and delete AirPortBrcm4360_Injector.kext, then do a clean snapshot.- wintersun52
- Post #6
- Forum: 11.00 Big Sur
-
Solved: Stuck at IOConsoleUsers: gIOScreenLockState 3, hs 0, bs 0, now 0, sm 0x0 with GT710 (GK208)
Hi I have had success with a similar setup, I cannot boot with the latest Kernel Patches the problem is patch 32, when i replace - uXcCAAC4BgYGBroGBgYGDzAPCQ== With this : uXcCAAC4BgEHALoGAQcADx9AAA== Using PlistEdit Pro it boot every time with no problems.- wintersun52
- Post #28
- Forum: 10.15 Catalina
-
GPU Performance Improved
Tried the updated patch again this time with a NVIDIA Quadro K600 as with a EVGA GT710, boots but goes to HDMI-no signal, then tried a Sapphire RX580 Pulse this time fully booted to desktop but HDMI audio is garbled. So changed back to the old patch and all three cards are working fine.- wintersun52
- Post #20
- Forum: Announcements
-
GPU Performance Improved
Tried the updated Patches with OpenCore 0.6.2 system boots OK but get this message-HDMI-no signal, revert back to the old Patches and system boots all the way. Is there anything I can do.- wintersun52
- Post #9
- Forum: Announcements
