I made some progress today.
About this Mac now says what kind of Mac it is and the serial number shows.
FaceTime and Messages working internal mic is working
Things to work on
1. Figure out why the screen boots up dim then takes about 3 to 4 minutes to get bright.
2. I can put the laptop to...
Thank you for that config.plist it works but the screen backlight is very dim while booting up and it takes about 3 to 4 minutes then the brightness comes back.
In About this Mac
Mac doesn't say the name of the MacBook Air
Processor says 1.19 Ghz Unknown
Serial Number Unavailable.
My wifi card has a USB 2.0 cable connected to the header on the motherboard. USB 2.0 Ports on the back is working. I needed to use a kext to discover all my ports to enable my USB 2,0 both onboard and on the back of the Motherboard.
After disconnecting the power cord, and removing the Cmos battery, press and hold down the power button for a few seconds
wait about 30 seconds then put back the Cmos battery, power cord power on then go into bios and adjust you settings you had previously to allow Mac to boot on your...
1. mount my efi folder
2. added the kext into the kext folder
3. open properTree-Master open select efi then OC snapshot then OC clean snapshot kext is listed under kernel its #7 for me
PlatformInfo processor type change from 0 to 1537
4. save and reboot reset NVRAM also
still the same
After reading through some links, I found out I needed 2 additional kext in addition to the LucyRTL8125Ethernt kext
RehabMan-FakePCIID and FakePCIID_intel_I225-V kext
Open Hackintool click PCIe under subclass look for your Ethernet Controller
under Device Path section, right...